Henny Penny HHC-980 Technical Manual page 18

2-2. TECH MODE (Continued)
2-4
T15: Humidity - Calibration/Offset/Highest
A user calibration to make sure the display shows the actual
humidity inside the cabinet
Press and hold and use
match the actual temperature. (+/-15
Press and hold to change the amount of the offset. (+/-15
Press and hold to view the highest air temperature recorded.
Press to reset highest temperature.
o
T16: CPU - Control Temperature - Highest Value
Shows the highest temperature the control board was exposed
to
T17: View ADC Channel
Factory use only
T18: Outputs/Inputs
The following components can be tested:
toggles the solenoid off and on.
toggles the cooling fan off and on.
toggles the water heater off and on.
toggles the air heaters off and on.
T19: Total Initialization
Completely resets any accumulated information and changed
settings in the controls; contact Henny Penny Corp. before
completing this step!
Model HHC-980/983
to set the display to
F)
o
F)
o
904