Henny Penny HHC-980 Technical Manual page 17

2-2. TECH MODE (Continued)
904
T10: Air Temperature - Calibration/Offset/Highest
A user calibration to make sure the display shows the actual air
temperature
Press and hold and use
match the actual temperature. (+/-15
Press and hold to change the amount of the offset. (+/-15
Press and hold to view the highest air temperature recorded.
Press to reset highest temperature.
T11: Water Heater Temperature - Circuit Calibration
Factory use only
T12: Water Heater Temperature - Calibration/Offset/
Highest
A user calibration to make sure the display shows the actual
water heater temperature
Press and hold and use
match the actual temperature. (+/-15
Press and hold to change the amount of the offset. (+/-15
Press and hold to view the highest air temperature recorded.
Press to reset highest temperature.
T13: Humidity - Circuit Calibration
See Humidity Sensor Calibration and Replacement Section
T14: Humidity Sensor - Calibration/Offset
A specific value that is sent with the humidity sensor, when
necessary; otherwise, this value should be 0
Model HHC-980/983
to set the display to
F)
o
to set the display to
F)
o
F)
o
F)
o
2-3