Leuze electronic MA 235i Operating Instructions Manual page 45

Selected scanner
Gateway mode
Ring buffer fill level
Received ASCII Frames
ASCII Framing Error (GW)
Number of Received CTB's
Number of Received SFB's
Command-Buffer fill level
Number of send fieldbus frames
Number of invalid commands
Table 9.3:
ND
Data loss
Table 9.4:
ASCII-Start-Byte
ASCII-End-Byte1
ASCII-End-Byte2
ASCII baud rate
ASCII warm start status
Table 9.5:
Input Data length
Output Data length
Node ID
Baud Rate[kBaud]
Table 9.6:
Leuze electronic
Currently selected Leuze device (selected via switch S4).
Transparent or Collective mode.
Current fill level of the ring memory in Collective mode (ASCII->Fieldbus).
1024 bytes max.
Number of received ASCII frames.
Number of received framing errors.
Number of CTB commands.
Number of SFB commands.
Current fill level of the ring memory in Command mode (fieldbus->ASCII).
1024 bytes max.
Number of frames sent via the fieldbus.
Number of invalid commands.
General gateway information
Current status of ND bit.
Current status of data loss bit.
Current states of the status and control bits
Currently configured start byte
(dependent on switch position S4).
Currently configured stop byte 1
(dependent on switch position S4).
Currently configured stop byte 2
(dependent on switch position S4).
Currently configured baud rate
(dependent on switch position S4).
Indicates whether the ASCII memory has detected and accepted a valid config-
uration.
ASCII configuration
Length of the data received (Rx, 8Byte).
Length of the data supplied (Tx, 8Byte).
Participant address of the address switch.
Set baud rate.
CANopen parameters MA 235
MA 235i
Configuration
43