Leuze electronic MA 235i Operating Instructions Manual page 14

Fast commissioning / operating principle
Set CANopen baud rate on the MA
The CANopen baud rate is defined for the entire network in the planning tool/control. The
baud rate is set on the MA
the same is communication with the MA
 Set the baud rate of the gateway via the S3 rotary switch to the value defined in the control.
Figure 3.3:
 Finally, close the housing of the MA 235i.
Attention!
Only then may the supply voltage be applied.
Upon startup of the MA 235i, the device selection switch is queried and the gateway auto-
matically sets itself to the Leuze device.
Connecting functional earth FE
 Ensure that the functional earth (FE) is connected correctly.
Unimpaired operation is only guaranteed when the functional earth is connected properly.
All electrical disturbances (EMC couplings) are discharged via the functional earth connec-
tion.
12
235i via the baud rate selector switch. Only if the baud rates are
Rotary switch for setting baud rate
Switch position
0
1
2
3
4
5
6
7
8
9
235i possible.
Baud rate [kBd]
auto
10
20
50
100
125
250
500
800
1000
MA 235i Leuze electronic