Connecting The Power Supply And The Bus Cable; Starting The Device; Ma 235 On The Canopen - Leuze electronic MA 235i Operating Instructions Manual

3.3.2

Connecting the power supply and the bus cable

 Ideally, use the ready-made cables listed in chapter 14.5.3 to connect the gateway to the
power supply via the PWR IN connection.
 The ready-made cables listed in chapter 14.6.4 are preferred for connecting the gateway
to the fieldbus via the HOST / BUS IN connection.
 If applicable, use the BUS OUT connection if you would like to construct a network with
linear topology.
3.4

Starting the device

 Apply the supply voltage +18 ... 30VDC (typ. +24VDC); the MA
The PWR LED displays that it is ready for operation.
3.5 MA 235i
 Install the EDS file corresponding to the MA
Notice!
You can find the EDS file at: www.leuze.com
The MA 235i
is assigned an address in the planning tool, which then has to be set in the MA
S1 and S2 address switches. Only if the addresses are the same between the MA
the control can communication be established.
After all parameters have been set in the planning tool/control, the download to the MA
takes place. The set parameters are now stored on the MA 235i.
Afterwards, all MA
retaining the parameters during device exchanges, as they a re now also stored centrally in
the control.
The CANopen baud rate is defined for the entire network in the planning tool/control. The
baud rate is set on the MA
Only if the baud rates are the same is communication with the MA
Detailed information can be found in chapter 12.
Leuze electronic
on the CANopen
is configured in the planning tool/control by means of the EDS file. The MA
235i parameters should be stored via upload in the control. This aids in
235i
Fast commissioning / operating principle
235i
via the S3 baud rate selector switch.
MA 235i
235i starts up.
in your planning tool/the control.
235i possible.
235i
235i via the
235i and
235i
13