Bps 300I Bar Code Positioning System, Odsl Xx Optical Distance Sensors With Rs 232 Interface (S4 Switch Position B) - Leuze electronic MA 235i Operating Instructions Manual

16.11 BPS 300i bar code positioning system, ODSL xx optical distance sen-
sors with RS 232 interface (S4 switch position B)
Notice!
In this switch position, 6-byte data (fixed) is always expected by the device. This is why a
quick telegram sequence can be transmitted reliably even without a data frame.
BPS 300i
Specifications for the serial interface
Default parameter
Baud rate
Data mode
Handshake
Protocol
Frame
Specifications for Command mode
To activate the Command mode, bit 0 must be set to 1 in control byte 0.
For further information, see chapter 11.1.3 "Command mode", figure 11.2.
Control bit
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Recommended settings
• Input data: 8 bytes
Use of the Collective mode for codes with a number of digits > 4.
• Output data: 8 bytes
Leuze electronic
BPS 300i
38400
8N1
no
binary protocol without acknowledgment
<Data>
Meaning
Transmit individual position value = single shot
Cyclically transmit position values
Stop cyclical transmission
Laser diode on
Laser diode off
Transmit single speed value
Cyclically transmit speed values
Transmit single position and speed value
Cyclically transmit position and speed values
Transmit marker information
Not used / reserved
Transmit diagnostic information
Activate standby
Specifications for Leuze end devices
MA 235i
Corresponds to
serial command
(ASCII)
C0F131
C0F232
C0F333
C0F434
C0F535
C0F636
C0F737
C0F838
C0F939
C0FA3A
C0FC3C
C0FD3D
91