Bus Out; Termination Of The Canopen Bus - Leuze electronic MA 235i Operating Instructions Manual

 For the host connection of the MA 235i, the ready-made "KB DN/CAN-xxxxx-Bx" cables
are preferred, see table 14.5 Bus connection cable for the MA 235ion page 77.
7.4

BUS OUT

BUS OUT
CAN_L
3
M12 socket
Table 7.4:
 For the host connection of the MA 235i, the ready-made "KB DN/CAN-xxxxx-Bx" cables
are preferred, see table 14.5 Bus connection cable for the MA 235ion page 77.
If you use user-configurable cables, note the following:
Notice!
Ensure adequate shielding. For the devices and ready-made cables offered by
Leuze electronic, the shield is on PIN 1.
7.4.1

Termination of the CANopen bus

If the gateway is the last physical CANopen participant in the trunk line, it must be terminated
with a terminating resistor (see "Accessory terminating resistor" on page 74).
Notice!
Stub cables must not be fitted with terminating resistors. If the MA
stub cable, the BUS OUT connection must not be terminated.
Leuze electronic
BUS OUT (5-pin socket, A-coded)
CAN_H
4
5
1 DRAIN
2
(A-coded)
Pin assignment HOST/BUS OUT
Pin Name
1 Drain
2 V+
3 V-
4 CAN_H
5 CAN_L
Thread FE
MA 235i
Electrical connection
Remark
Shield
Supply voltage data V+
Supply voltage data V-
Data signal CAN_H
Data signal CAN_L
Functional earth (housing)
235i is integrated into a
31