Operation Of The Operating Light Kavolux 540 Led (Optional) - KaVo Primus 1058 Life Short Instructions For Use

Short instructions for use 8 Operation of the operating light KaVoLUX 540 LED (op‐
tional)

8 Operation of the operating light KaVoLUX 540 LED (optional)

The KaVoLUX 540 LED operating light can be used in the following modes:
• Normal light: preset at 5,500 Kelvin and 30,000 Lux corresponding to daylight quality
• COMPOsave-Modus: enables longer processing periods for composites by filtering the blue com‐
ponents of the light
• Dimmed light: approx. 4,000 Kelvin; equivalent to the light of a halogen operating lamp
▪ Laser mode: Light mode, which has no negative influence on the KaVo KEY Laser III, the KEY
Laser 3+ or the KaVo DIAGNOdent.
Turning the operating light On and Off
Note
Activate the KaVoLUX 540 LED operating light using the "Operating light" key on
the assistant element. Only then the operating light can be operated by means of
the sensor and the control panel of the operating light.
Sensor / control panel KaVoLUX 540 LED T
①
"Operating light" key
③
"Mode/ colour temperature" button
▶ Press the "Treatment light" button.
ð
or
▶ Hold your hand just in front of the sensor.
ð Treatment light is switched on, Display LED shining.
▶ Press the "operating light" button once again.
or
▶ Hold your hand just in front of the sensor.
ð Treatment light is switched off, Display LED not shining.
Setting the brightness
▶ Press and hold down the "Treatment light" key.
ð Signal buzzes, brightness changes from dark to bright in stages.
▶ When the desired brightness is reached, release the "Treatment light" key.
②
"Operating light dimming" key
21