HomeMatic HM-LC-BI1PBU-FM Installation And Operating Manual page 61

8.2.1 Teaching-in to Homematic devices
If you would like to teach-in the actuator to one or more
Homematic devices, you must put the devices to be
taught-in into teach-in mode and select the required
teach-in channel. To do this, proceed as follows:
During teach-in, please make sure you maintain
a distance of at least 50 cm between the devices.
• Briefly press the Config button of the actuator with a
pointed object (e.g. ballpoint pen) to start the 20-se-
cond teach-in mode again.
• Flashing of the LED in the Config button indicates that
teach-in mode is active.
• Now put the device you wish to teach-in the actuator
into teach-in mode and select the required channel
button if necessary. Please follow the relevant opera-
ting manual instructions of the corresponding device.
• A soon as both components have completed the
teach-in procedure, the LED's go off and the actuator
can be operated via the transmitter in a standard
configuration.
If no teach-in operations are carried out, teach-in
mode will be exited automatically after 20 se-
conds.
61