HomeMatic HM-LC-BI1PBU-FM Installation And Operating Manual page 42

Using the device for any purpose other than
that described in this operating manual does
not fall within the scope of intended use and
shall invalidate any warranty or liability.
The actuator that is described is part of the
building installation. The relevant national
standards and directives must be taken into
consideration during planning and set-up. The
device has been designed solely for operation
on a 230 V/50 Hz AC supply. Only qualified
electricians (to VDE 0100) are permitted to car-
ry out work on the 230 V mains. Applicable ac-
cident prevention regulations must be complied
with whilst such work is being carried out. To
avoid electric shocks from the device, please
disconnect the mains voltage (trip the miniature
circuit-breaker). Failure to follow the installation
instructions can result in fires or other hazards
(see also Chapter „7 Installation" on page 48).
Please do not open the actuator. It does not
contain any parts that can be maintained by the
user. In the event of a fault, please call our ser-
vice department.
42