Mechanical Installation; Unpacking; Installation Environment; Mounting - Danfoss VLT Midi Drive FC 280 Operating Instructions Manual

Mechanical Installation

3 Mechanical Installation

3.1 Unpacking

3.1.1 Items Supplied
Items supplied may vary according to product configu-
ration.
•
Make sure the items supplied and the information
on the nameplate correspond to the order confir-
mation.
•
Check the packaging and the frequency converter
visually for damage caused by inappropriate
handling during shipment. File any claim for
damage with the carrier. Retain damaged parts
for clarification.
1
2
3
4
5
6
CAUTION:
SEE MANUAL
WARNING:
STORED CHARGE DO NOT TOUCH UNTILL 4 MIN. AFTER
DISCONNECTION
RISK OF ELECTRIC SHOCK-DUAL SUPPLY DISCONNECT MAINS
AND LOADSHARING BEFORE SERVICE
12
1 Type code
2 Order number
3 Power rating
Input voltage, frequency, and current (at low/high
4
voltages)
Output voltage, frequency, and current (at low/high
5
voltages)
6 Enclosure type and IP rating
7 Disposal
8 CE mark
9 Serial number
10 Functional safety
11 Rated ambient temperature
12 Discharge time (Warning)
Illustration 3.1 Product Nameplate (Example)
NOTICE
Do not remove the nameplate from the frequency
converter (loss of warranty).
MG07A102
Operating Instructions
3.1.2 Storage
Ensure that requirements for storage are fulfilled. Refer to
chapter 9.4 Ambient Conditions for further details.

3.2 Installation Environment

NOTICE
In environments with airborne liquids, particles, or
corrosive gases, ensure that the IP/Type rating of the
equipment matches the installation environment. Failure
to meet requirements for ambient conditions can reduce
lifetime of the frequency converter. Ensure that
requirements for air humidity, temperature, and altitude
are met.
Vibration and shock
7
8
The frequency converter complies with requirements for
units mounted on the walls and floors of production
9
premises, as well as in panels bolted to walls or floors.
10
For detailed ambient conditions specifications, refer to
chapter 9.4 Ambient Conditions.
11

3.3 Mounting

NOTICE
Improper mounting can result in overheating and
reduced performance.
Cooling
•
Lifting
•
•
•
•
Danfoss A/S © 11/2015 All rights reserved.
Ensure 100 mm of top and bottom clearance for
air cooling.
To determine a safe lifting method, check the
weight of the unit, see chapter 9.9 Enclosure Sizes,
Power Ratings, and Dimensions.
Ensure that the lifting device is suitable for the
task.
If necessary, plan for a hoist, crane, or forklift with
the appropriate rating to move the unit.
For lifting, use hoist rings on the unit, when
provided.
3 3
7