Resetting Jobs (Welding Tasks) To The Factory Settings - EWM Expert XQ 2.0 Operating Instructions Manual

Category
a) b)
60
61
62
[1]
factory setting
[2]
option
[3]
only machine series Titan
[4]
not machine series Titan
7.4

Resetting JOBs (welding tasks) to the factory settings

All customised welding parameters that are stored will be replaced by the factory settings.
Instructions on how to reset welding tasks (JOBs) to the factory setting can be found in the JOB mana-
ger > see 5.6.3 chapter chapter.
099-00L105-EW501
07.06.2019
Error Possible cause
c)
Incompatible A machine's software is not
software compatible.
Welding moni- The actual value of a welding
tor parameter is outside the spe-
cified tolerance field
System com- System component not found
[3]
ponent
Resetting JOBs (welding tasks) to the factory settings
Remedy
Inform Service
Observe tolerance fields; ad-
just welding parameters
Inform Service
Rectifying faults
83