Machine Configuration (System); Power-Saving Mode (Standby) - EWM Expert XQ 2.0 Operating Instructions Manual

Operating the machine control

Machine configuration (system)

The user can switch the lock function on or off by pressing the button for a long time from each machine
control or accessory component with the symbol
5.4 Machine configuration (system)
In the System menu the user can set the basic machine configuration.
Enter the menu:
5.4.1

Power-saving mode (Standby)

You can activate the power-saving mode by setting a parameter in the configuration menu (time-
controlled power-saving mode). When power-saving mode is active, the Expert XQ 2.0 machine controller
display is dimmed and only the middle digit of the display is shown in the wire feed unit. Pressing any
operating element (e.g. tapping the torch trigger) deactivates power-saving mode and the machine is
ready for welding again.
Menu item/parameter
Time automatic [min.]
Log off user in standby mode
18
.
Figure 5-1
Value Comment
Off Function switched off
5-60 Time to activation of the power-saving mode in
case of inactivity.
Yes The user will be logged off when the power-
saving mode is active.
No The user will not be logged off when the power-
saving mode is active.
099-00L105-EW501
07.06.2019