Checking the Setting
z To check the currently set value, press the [CALL] key. The currently set value will be displayed while
the [CALL] key is held down.
Changing the Setting
If you want to change the currently set value while measurement is in progress, carry out
steps 4 to 9.
z The value you are going to set must be larger than the currently set value. If a value smaller than
currently set value is set, "Err A" will appear, causing the SET mode to be exited.
24
11
The unit will blink, indicating that measurement is currently
paused.
z This also occurs in normal and ⊿ modes.
12
Set the power switch to "O" (OFF).
z If the power switch is not set to "O" (OFF) to reset the instrument,
it will also be impossible to perform measurement in other modes.