Table of Contents
Advertisement
FEATURES AND FUNCTIONS
Top handle / lifting bracket
for safe tool use
PASS / FAIL
lights
Factory calibrated to ± 3%.
Using patent pending "Intelligent Joint Sensing" technology to continually measure the joint during
tightening. As the fastener is tightened the tool will sense the joint type (hard / soft) and act accordingly.
As the fastener is tightened dynamic braking is used to ensure the target torque is correctly reached
and eliminate the potential for a large over torque due to tool inertia.
Models covering 5 torque ranges up to 6000 N·m.
Very quiet operation.
Very low vibration levels using a non-impacting mechanism; this leads to comfortable and safe
use with less damage to the tool, socket and threaded assembly.
IP44 environmental rating (protection against 1mm solid objects & splashing water).
Versions for 110 V a.c. or 230 V a.c.
Reaction forces are contained by the reaction bar, so forces are not passed back to the operator.
Several reaction bar styles available, including versions for restricted applications.
Torque mode & Angle mode.
Tool calibrated from 20% to 100% of rated torque capacity.
Brushless motor for low maintenance.
Tool mode (TARGET /
SET TARGET / RUN)
RED fail light
Target setting buttons
8
Drive square
Ergonomic
trigger control
ON/OFF
switch
FIGURE 1 – Tool Features
RUN
360°
X
2000
N .
Settings
FIGURE 2 – User Interface Features
Reaction bar
Cooling
Fan
User
interface
Mains lead
Display showing torque,
units, angle and direction
GREEN pass light
Units of N·m
or lbf·ft.
Clockwise / counter-
clockwise selector
Advertisement
Table of Contents
