For Accurate Learning - Sony RM-VL900 Operating Instructions (primary manual) Operating Instructions Manual

Using Unpreset Remote Control
Operations
— Learning Function (continued)
When you "teach" signals to the
VOL +/– or MUTING buttons
•If you have programmed any
signal on the VOL +/– or
MUTING button for components
other than TV and AMP using
the Learning function, that
signal will be transmitted only
when you select that component.
•If you have programmed any
signal on the VOL +/– or
MUTING button for TV or AMP
using the Learning function, that
signal will be transmitted only
after you select TV or AMP.
When you select other
components, the preset volume
control signals for TV or AMP
will be transmitted (for the
difference between visual
components and audio
components, see page 21). To use
the "learned" signal, you need to
program the VOL +/– or
MUTING button for each
component using the Learning
function.
To "teach" the signals for an air-
conditioner
See "Programming a Frequently
Used Key Operation for SYSTEM
CONTROL Buttons" on page 35.
18

For accurate Learning

•Do not move the remote units
during the Learning procedure.
•Be sure to keep holding down
the "learning" button until your
Commander reacts as described.
•Use fresh batteries in both
remote units.
•Avoid Learning in places under
direct sunlight or a strong
fluorescent light.
•The remote control detector area
may differ depending on each
remote unit. If Learning does not
work, try changing the positions
of the two remote control units.
•When you teach signals of an
interactive signal exchange
system remote control unit
(supplied with some of Sony's
receivers and amplifiers) to the
Commander, the response signal
of the main unit may interfere
with the learning of the
Commander. In such a case,
move to a place where the
signals will not reach the main
unit (e.g. other rooms, etc.).
IMPORTANT
Be sure to place the
Commander out of the reach of
small children or pets.
Components such as air
conditioners, heaters, electric
appliances, and electric
shutters or curtains receiving
an infrared signal can be
dangerous if misused.