For Accurate Learning - Sony RM-VL610T Operating Instructions Manual

If the SET indicator flashes five times
It means that "learning" is incomplete. Repeat steps 4
and 5.
6
Repeat Steps 4 and 5 to "teach" functions
to other buttons.
To "teach" another component's remote
control signal
After positioning the two remote commanders as in
Step 1 on page 12, press the corresponding Component
Select button, and then follow Steps 4 and 5 to perform
Learning.
7
Press SET to finish setting.
Notes
• If you do not perform Learning steps within 20 seconds
at any point during the process, Learning mode ends.
• If you do not perform Step 5 within 10 seconds after Step
4, the learning procedure returns to Step 3. Repeat Step 4
while the Component Select button lights.
To cancel setup, press SET.
If the Commander does not seem to be
working
If the "learned" button does not operate properly, "teach"
once again. (For example, if the volume becomes very loud
after pressing 2 + only once, noise may have interfered
during the Learning procedure.)
If you set a component code after "learning" a
signal
If you have programmed any signal on a button by the
Learning function, that signal will work even after you set
a component code.
Note on the REC z signal
You can only "teach" to one button at a time. Therefore you
cannot teach a sequential button operation (for example
REC z + G) to a single button on the Commander. In this
case, "teach" the combined function of the buttons on your
component to the Commander.
When you "teach" signals to 2 +/– or %
•If you used the Learning function to programme
the 2 +/– or % buttons to send any signal to
components other than the TV or AMP, that signal
will be transmitted only by pressing 2 +/– or %
when you select that component.
•If you used the Learning function to programme
the 2 +/– or % buttons to send any signal to the
TV or AMP, that signal will be transmitted only
after you select TV or AMP. When you select other
components, the "learned" signal will be
transmitted.
14
To "teach" the signals for an
air-conditioner
See "Notes on programming the signals for an air-
conditioner" on page 18.

For accurate Learning

• Do not move the remote units during the
Learning procedure.
• Be sure to keep holding down the "learning"
button until your Commander reacts as described.
• Use fresh batteries in both remote units.
• Avoid Learning in places subject to direct sunlight
or a strong fluorescent light. (Noise may interfere
during the Learning procedure.)
• The remote control detector area may differ
depending on each remote unit. If Learning does
not work, try changing the positions of the two
remote control units.
• When you teach signals of an interactive signal
exchange system remote control unit (supplied
with some of Sony's amplifiers) to the
Commander, the response signal of the main unit
may interfere with the learning of the
Commander. In such a case, move to a place
where the signals will not reach the main unit (e.g.
other rooms, etc.).
IMPORTANT
Be sure to place the Commander out of the reach
of small children or pets, and lock the controls
using the Hold function (page 25).
Components such as air - conditioners, heaters,
electric appliances, and electric shutters or
curtains receiving an infrared signal can be
dangerous if misused.