Sony RM-VL900 Operating Instructions (primary manual) Operating Instructions Manual page 33

In this example, press the
Number 5 button to select CD.
1: VCR
2: VD
3: SAT
4: AMP
5: CD
6: TAPE
Note
Only the function to this step is
assigned. Other "learned" functions
are not assigned.
4
•If you need to set the
component code, follow
the steps on pages 8 or 11.
•If you need to program
some signals by the
Learning function, follow
the Steps 1 and 3 to 7 on
pages 15 to 17.
7: MD
8: TV
9: CBL
0: DVD
To reset a Component Select
button to its original setting
1
Press and hold S (set) for
over 3 seconds.
The S (set) indicator lights up,
and all Component Select
buttons flash.
2
While holding x pressed,
press the desired
Component Select button.
The S (set) indicator turns off,
and the selected Component
button lights up.
Note
Through this operation, you can
only erase the "learned" functions
to all buttons on a specific
component and the Channel Macro
function. The "learned" functions to
the Component Select buttons
cannot be changed here. You must
be sure beforehand, of which
"learned" function you want to
erase.
3
Press S (set) to finish
setting.
Continued
33