Sony RM-VL900 Operating Instructions (primary manual) Operating Instructions Manual page 9

3
Press the Component Select
button for the desired
component.
The selected Component
button lights up, and all other
buttons turn off.
4
Press the Number buttons
to enter the three-digit
component code number.
The selected Component
button turns off each time you
press a Number button.
5
Press ENT.
The Component button turns
off.
If the Component button
flashes five times before
turning off, it means that the
setup is incomplete. Start over
from Step 2.
Notes
• If you press a component code
number that is not on the table in the
supplied "Component Code
Numbers", or if you press a button in
an improper order, the Component
button flashes five times, and then
turns off. Check the component code
number, and try setting again.
• If you don't input anything into the
Commander for over 20 seconds
between each step, the setup
procedure will be canceled. To set the
code, start over from Step 2.
• If you press S (set) while setting the
component code, all code numbers
will be lost, and the setup procedure
will be canceled. Start over from Step
2.
To cancel setup, press S (set).
Continued
9