Download Print this page

Sony RM-VL900 Operating Instructions (primary manual) Operating Instructions Manual page 41

Remote controls: integrated remote commander
Hide thumbs

Advertisement

3
While holding cursor V
pressed, press the Number
1 button.
The S (set) indicator flashes
and all Component Select
buttons light up.
4
Confirm that the sending
remote commander is ready
for data transfer.
(To set the sending
commander, follow the
procedure on page 38.)
Note
Be sure that the sending remote
commander is ready to transfer
data.
5
Press ENT.
The S (set) indicator lights up
and all Component Select
buttons turn off (data-reception
standby).
6
Press ENT (ENTER) on the
sending remote
Commander.
As the data is received, the
corresponding Component
Select buttons light up one by
one.
If data transfer has been
unsuccessful during or after
the procedure, the S (set)
indicator and all Component
Select buttons flash five times,
and the Commander returns to
its state in Step 5. Either try
again from Step 6, or press S
(set) to cancel data receival.
Note
If you do not perform Step 6 within 10
seconds, the S (set) indicator and all
Component Select buttons flash five
times, followed by a short pause, and
then flash again.
Continued
41

Advertisement

loading

  Also See for Sony RM-VL900 Operating Instructions (primary manual)

  Related Manuals for Sony RM-VL900 Operating Instructions (primary manual)