Clearing Programmed Steps Of A Component Macro - Sony RM-VL1400T Operating Instructions Manual

3
While pressing the SCROLL
button, press the
COMPONENT select button
or Label select button to
which the desired Component
Macro has been programmed.
"MACRO" and the selected A/V
component name appear on the first
line and the programmed steps are
listed on the screen.
4
Press the V/v buttons so that
the position of the delay
appears in the third line on the
screen, then press the
SCROLL button.
Delay is added between the second
line and the third line on the screen,
and "[DELAY]" appears in the third
line on the screen.
5
Press the OK button or centre
Label select button.
A beep sounds and programming is
complete.
6
Press the
the RETURN button twice.
The set mode closes, and the Remote
Commander returns to standby for
operating the A/V components.
Notes
• If remote sensors of A/V components are too
far apart from each other, or they are covered,
consecutive operation steps programmed on a
Component Macro may not be executed.
• If a Component Macro is not executed
properly for any reason, such as mentioned
above, be sure to set all the A/V components
to the status before the Component Macro was
executed. Otherwise, A/V components will
not work properly next time the Component
Macro is executed.
• Because some A/V components are designed
to turn on/off each time they receive the
power on/off signal, those components may
not be turned on with the Component Macro.
Check the power on/off status of the A/V
components before using the Component
Macro.
GB
20
(light) button or
Clearing programmed
steps of a Component
Macro
If you make a mistake in programming
steps or you want to programme a new
Component Macro, follow the procedure
below to clear the Component Macro.
1
While pressing the
button, press the OTHER
button.
"SET MODE" appears as the screen
title.
2
Press the V/v buttons to
select "4 MACRO", then press
the OK button or the centre
Label select button.
"MACRO" appears as the screen title.
Tip
If a number is displayed before the menu,
you can select the menu by pressing the
number button.
3
While pressing the
COMPONENT select button
or Label select button on
which the Component Macro
has been programmed, press
the (light) button.
A beep sounds and the Component
Macro is cleared.
4
Press the
the RETURN button twice.
The set mode closes, and the Remote
Commander returns to standby for
operating the A/V components.
(light)
(light) button or