Programming A Signal On The Component Select Button - Sony RM-VL1400T Operating Instructions Manual

Notes
• If you do not input anything into the Remote
Commander within 60 seconds between each
step, the setup procedure will be cancelled
and the set mode closes. Start over from the
beginning.
• If you do not perform step 6 within 10
seconds after performing step 5, a beep
sounds twice and the selected button name
and "NG" appear in the third line on the
screen, then the display returns to the screen
shown in step 4. Start over from step 5.
• If the Remote Commander learns signals
incorrectly in step 6, clear the learned signal
by pressing the
pressing the button on which the incorrect
signal was learned (page 14). Start over from
step 5.
• If you programme remote signals on the TV
or amplifier's volume control buttons using
the Learning function (page 12), those buttons
will also send the learned signal to control
components other than a TV or amplifier.
If you programme remote signals on the
volume control buttons of components other
than a TV or amplifier, those buttons will also
send the learned signal to control other A/V
components instead of controlling the TV or
amplifier's volume.
• To avoid misoperation, the Remote
Commander will only transmit z/REC
(record) button signals if the button is pressed
and held for over 2 seconds. Therefore, if this
button is used for a learned operation, you
must press and hold it for over 2 seconds.
(light) button while
Programming a signal on
the COMPONENT select
button
1
Perform steps 1-3 of the
learning procedure (page 12).
2
Press and hold the
COMPONENT select button
or Label select button on
which you want to programme
the signal.
The display turns off and the Remote
Commander enters into the Learning
mode.
3
Press and hold the button on
the other remote control until
you hear a beep.
A beep sounds and the learned button
name and "OK" appear in the third
line on the screen.
4
To programme signals on
other COMPONENT select
buttons or Label select button,
repeat steps 2 and 3.
5
Press the
"LEARN" appears as the screen title.
6
Press the
the RETURN button twice.
The set mode closes, and the Remote
Commander returns to standby for
operating the A/V components.
(light) button.
(light) button or
Continued
GB
13