Setting A/V Components Which Are Not Listed In The Preset Code List - Sony RM-VL1400T Operating Instructions Manual

5
Press the number buttons to
enter the four-digit preset
code, then press the OK
button or the centre Label
select button.
Example: To enter "8095"
Press 8, 0, 9, 5 then the OK button.
A beep sounds, and the four-digit
preset code you have set and "OK"
appear on the screen, then the display
returns to the screen shown in step 3.
6
To set preset codes for other
A/V components, repeat steps
4 and 5.
7
Press the
RETURN button twice.
The set mode closes, and the Remote
Commander returns to standby for
operating the A/V components.
Notes
• If you enter a preset code that is not on the
table in the supplied "Preset Code List" and
press the OK button, a beep sounds five times,
and the entered four-digit number and "NG"
appear on the screen, then the display returns
to the screen shown in step 4. Check the
preset code, and try entering the code again.
• If you do not enter anything into the Remote
Commander within 60 seconds between each
step, the setup procedure will be cancelled
and the set mode closes. Start over from the
beginning.
• The Remote Commander recognizes the A/V
component type when a preset code is entered
in step 5, and the screen title displayed when
operating the A/V component is determined.
If the screen title does not correspond with the
component you have set, you can change the
component label accordingly.
• You cannot set A/V components after you
programme other remote control signals using
the Learning function (page 12), programme a
Component Macro (page 18), or change the
label (page 15). In such a case, reset the A/V
component settings (page 28), then set the
A/V components again.
GB
8
(light) button or the
Setting A/V components
which are not listed in the
Preset Code List
—Search function
You can set A/V components which are
not listed in the supplied "Preset Code
List" using the search function.
Before starting the search
function
Set each A/V component to the following
status so that the search function works
effectively.
TV, AMP: Power-on
CD player, MD deck, Casssette deck:
Power-on with a playback source.
Other component: Power-off
1
While pressing the
button, press the OTHER
button .
"SET MODE" appears as the screen
title.
2
Press the V/v buttons to
select "1 PRESET", then press
the OK button or the centre
Label select button.
"PRESET" appears as the screen title.
Tip
If a number is displayed before the menu,
you can select the menu by pressing the
number button.
3
Press the COMPONENT
select button for the desired
A/V component.
The selected A/V component's label
and the preset code currently set
appear on the screen.
(light)