Sony RM-VL1400T Operating Instructions Manual page 32

Problem
You cannot operate a component
even after you programmed the
remote control signals with the
"learning" function.
"NG" appears in the third line on
the screen and a beep sounds five
times while setting the preset
code.
"NG" appears in the third line on
the screen and a beep sounds five
times while learning.
"FULL" appears in the third line
on the screen and a beep sounds
five times while learning.
"NG" appears in the third line on
the screen and a beep sounds five
times when trying to copy settings
of a component label to another
component label.
A beep sounds twice while setting
the preset code.
A beep sounds twice while
learning.
A beep sounds twice while
programming a Component
Macro.
"NG" appears in the third line on
the screen and a beep sounds
twice while programming the
power-on function.
GB
32
Solution
Make sure that the Remote Commander has learned the
correct signals. If not, see "Notes" on page 13 or "For
accurate learning" (page 14), and try the learning
procedure again (page 12).
Preset code setting has not succeeded. Set the preset code
again, referring to the supplied "Preset Code List".
• Learning has not succeeded. Try the learning procedure
again (page 12), referring to "For accurate learning"
(page 14).
• While learning, you pressed the button other than the one
on which you want to programme the signal. Programme
the signal on the correct button again (page 12).
Learned signal memory is full. Clear learned signals that
are not frequently used (page 14), then programme the
desired remote signal.
• Setting cannot be copied on COMPONENT select
buttons or Label select buttons in the following
situations:
– A learned signal or Component Macro is programmed.
– The button's component label has been changed.
– The button's function label has been changed.
In this case, reset those settings (page 28) before copying.
• You are copying the settings of A/V components other
than a TV or amplifier on the Label select button
assigned with a TV or amplifier. The TV button is
assigned with only TV and the Label select button to
which an amplifier is preset is assigned with only
amplifier or DVD player home theatre system.
• The Remote Commander fails to copy the settings if the
programmed signal data of the button is too large. In this
case, clear programmed signals that are not frequently
used (page 14), then copy the settings again.
The preset code cannot be set on the COMPONENT select
button or Label select button in the following situations:
– A learned signal or Component Macro is programmed.
– The button's component label has been changed.
– The button's function label has been changed.
In this case, reset those settings (page 28) before setting.
• See "For accurate learning" (page 14).
• Other remote signal has been programmed on the desired
button. Clear the learned signal (page 14) or programme
the remote signal on another button (page 12).
• Learning standby time (10 seconds) has been exceeded.
Start over from the beginning.
• You are assigning a Component Macro on the
COMPONENT select button or Label select button on
which another Component Macro has been assigned.
Clear the Component Macro assigned to the button (page
20), then assign the desired Component Macro.
• The programmed steps exceed 32 after adding delay
while checking the Component Macro. A maximum of 32
steps (including delay) can be programmed.
Reprogramme the Component Macro.
You are programming the power-on function (page 21) on
the COMPONENT select button or Label select button
assigned with a preset code other than Sony's. The power-
on function can be programmed only on the button
assigned with Sony's preset code.