Using The Series Of Commands (Component Macro); Programming A Component Macro - Sony RM-VL1400T Operating Instructions Manual

Using the Series of
Commands
(Component Macro)
You can set an operation programme
consisting of up to 32 steps (Component
Macro) on the COMPONENT select
button or Label select button
corresponding to any component.
For example, when you watch a DVD by
connecting a TV and DVD recorder to an
amplifier, a series of operations like the
ones below are necessary.
1 Turn on the TV.
2 Turn on the DVD recorder.
3 Turn on the amplifier.
4 Select the appropriate video input on the
TV to watch the DVD.
5 Select the appropriate audio input on the
amplifier to watch the DVD.
6 Start playing the DVD recorder.
The Component Macro enables you to
perform these steps by holding down one
of the COMPONENT select buttons or
Label select buttons for over 2 seconds.
GB
18
Programming a
Component Macro
Follow the procedure below to
programme a Component Macro. You can
programme up to 32 consecutive actions.
Example: To programme the
procedure above to the DVD
button
1
While pressing the
button, press the OTHER
button.
"SET MODE" appears as the screen
title.
2
Press the V/v buttons to
select "4 MACRO", then press
the OK button or the centre
Label select button.
"MACRO" appears as the screen title.
Tip
If a number is displayed before the menu,
you can select the menu by pressing the
number button.
3
Press the DVD button.
"MACRO DVD" appears as the
screen title.
Tip
To select A/V components which are not set
to the COMPONENT select buttons, press
the OTHER button repeatedly, then press
the Label select button corresponding to the
desired A/V component displayed on the
screen.
4
Press the TV button, then
press the 1 (power) button.
(light)