Checking If A Component Macro Is Executed Properly - Sony RM-VL1400T Operating Instructions Manual

5
Press the DVD button, the
press the 1 (power) button.
6
Press the OTHER button
repeatedly, press the Label
select button corresponding to
the amplifier, then press the 1
(power) button.
7
Press the t (input select)
button repeatedly to select the
appropriate video input on the
TV to watch the DVD.
8
Press the input select button
on the amplifier to select the
appropriate audio input to
watch the DVD.
9
Press the DVD button, then
press N.
10
Press the
A beep sounds and programming is
complete.
11
Press the
the RETURN button twice.
The set mode closes, and the Remote
Commander returns to standby for
operating the A/V components.
Notes
• If the procedure is interrupted at any point for
over 60 seconds, programming is cancelled.
You cannot continue from where you left off.
• If you try to programme actions on a button
that already has a programmed Component
Macro, a beep sounds twice to alert you that
you cannot programme a Component Macro
on the button. In such a case, clear the
programmed Component Macro (page 20),
then start programming again from step 1.
• You cannot clear steps during the
programming procedure. If you make a
mistake in programming actions, finish
programming once and clear the Component
Macro (page 20), then start again from step 1.
• You can programme up to 32 consecutive
operation actions. When up to 32 steps are
programmed, programming of the Component
Macro is full. To change the programmed
steps, clear the Component Macro (page 20),
then start over from step 1.
(light) button.
(light) button or
Checking if a Component
Macro is executed properly
Follow the procedure below to check if
the programmed Component Macro
works as intended.
To execute a Component
Macro
1
Press and hold the
COMPONENT select button
on which the desired
Component Macro has been
programmed for over 2
seconds.
The signal transmission icon appears
on the screen, and the programmed
Component Macro is executed.
Tip
While the signal transmission icon (
appears and the Component Macro is executed,
"CANCEL" appears in the third line of the
screen. You can cancel executing the
Component Macro by pressing the right Label
select button.
To check the programmed
steps of a Component Macro
and add a delay action
Delay action allows you to set an interval
between steps. Delay time is set to 250
ms. (1/4 second) on the Remote
Commander.
If a Component Macro is not executed as
intended, check the programmed steps
and try adding a delay to execute the
programme properly.
1
While pressing the
button, press the OTHER
button.
"SET MODE" appears as the screen
title.
2
Press the V/v buttons to
select "4 MACRO", then press
the OK button or the centre
Label select button.
"MACRO" appears as the screen title.
Tip
If a number is displayed before the menu,
you can select the menu by pressing the
number button.
)
(light)
Continued
GB
19