Copying The Settings Of A Component Select Button To Another Button - Sony RM-VL710 Operating Instructions Manual

Copying the settings of a
Component Select button
to another button
You can copy the entire settings of
a Component Select button to
another Component Select button.
The settings of the component
code (page 8) and the "learned"
function (page 14) are copied to a
new button.
SET
TV VCR CBL
1 2
4 5
7 8
0
Example: To copy the settings of
the DVD button to the CBL
button
1
Press and while holding
SET, press MENU.
All Component Select buttons
flash.
TV VCR
1
POWER
2
DVD AMP
3
6
9
ENT
1
CBL DVD AMP
2
Press and hold for over 3
seconds the desired
Component Select button to
which you want to copy a
setting from another
component.
While holding down this
button, the other Component
Select buttons flash. Then,
when you press the
Component Select button
which holds the setting you
want to copy, all Component
Select buttons light up. When
copying is complete, any
Component Select buttons
other than the two buttons
pressed, turn off.
TV VCR
TV VCR
TV VCR
TV VCR
To cancel setting, press SET.
Notes
• You cannot copy the settings to a
Component Select button on which
any "learned" function (page 14) has
been programmed.
• Since you can only operate a TV
using the TV Component Select
button, and you cannot copy other
Component Select button settings
(other than for a TV) to the TV
Component Select button.
• You cannot copy the Control Program
function (Component Macro) to
another Component Select button.
To return the setting of the
Component Select button to the
original component setting
Clear the "learned" function (page
20) and perform the original
component setting following the
procedure on page 31.
CBL DVD AMP
for over
3 seconds
CBL DVD AMP
CBL DVD AMP
CBL DVD AMP
31