Macro Control Block
MACRO
PRE
POST
MCRO
MCRO
2 POST MCRO button
1 PRE MCRO button
a PRE MCRO button
Use this button to set a macro attachment in pre macro
mode.
When you make settings in macro only mode, this button
is used together with the Macro Only Set button, assigned
to one of the buttons in the utility control block.
b POST MCRO button
Use this button to set a macro attachment in post macro
mode.
When you make settings in macro only mode, this button
is used together with the Macro Only Set button, assigned
to one of the buttons in the utility control block.
c ATTCH ENBL (attachment enable) button
When this button is on, macro attachments assigned to
buttons on the control panel are enabled.
ATTCH
ENBL
3 ATTCH ENBL button
Menu Control Block
1 Top menu selection buttons
MENU
TOP/
SHUT
DOWN
REG
FILE
SET
UP
DIAG
a Top menu selection buttons
Select the menu shown in the menu display.
• TOP/SHUTDOWN (top menu/shutdown) button
• REG (register menu) button
• FILE (file menu) button
• SET UP (setup menu) button
• DIAG (diagnostics menu) button
b Knobs
Use to adjust parameters shown in the menus.
Power Indicators, "Memory Stick"
Slot, USB Connector
A
POWER
B
1 Power A and B status indicators
2 "Memory Stick" status indicator
3 "Memory Stick" slot
4 USB connector
a Power A and B status indicators
Two power supplies (A and B) can be installed in the
control panel. When the control panel is powered on, the
indicators corresponding to the installed power supplies
light in green.
Menu display
2 Knobs
Control Panel Configuration
23