Sony MKS-2010 User Manual page 190

Block Byte
Block1 1
2
3
4
5
6
7
8
Block2 1
2
3
4
5
6
7
8
Making detailed settings for disk recorders (Sony
Disk 9-pin Protocol)
For disk recorders using the Sony Disk 9-pin Protocol
(called "DDR SD9P" below), settings are required to
specify response times until command execution.
The status area of the Port Setting menu for DDR SD9P
devices shows information about the selected port and a
list of response times.
DDR SD9P detailed settings screen
1
Using any of the following methods, select a response
time to set.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
Knob Description
3 (No) Setting item selection
a) 1: Maximum Open Delay (maximum time required to open a file)
2: Maximum Cueup Delay (maximum time required to cue up a file)
190
Other Settings
Setting
HI-BYTE (DEVICE TYPE)
LO-BYTE (DEVICE TYPE)
HI-BYTE (FRAME) (PREROLL
TIME)
LO-BYTE (FRAME) (PREROLL
TIME)
EDIT DELAY (FRAME)
EE DELAY (FRAME)
OVER RUN (FRAME)
TRAJECTORY
TC READ DELAY (FRAME)
START DELAY (FRAME)
AFTER SYNC DELAY –
AFTER SYNC DELAY +
MODE1
MODE2
MAX PRRL SPEED
QUICK PVW PRRL TIME (FRAME)
Setting values
a)
1 to 4
3: Play After Cueup Delay (delay time from the cued-up state to
begin playback)
4: Play After Open Next Delay (delay time from the Open Next state
to begin playback)
2
Turn knob 4 to set the response time.
Knob Description
4 (Setting) Response time
3
Press [Set].
The setting is confirmed.
Making detailed settings for disk recorders
(Video Disk Communications Protocol)
The following settings are required for disk recorders
using the Video Disk Communications Protocol (called
"DDR VDCP" below).
• Selection of whether to use the disk recorder as a
recorder or as a player
• Video port number
• Response times until command execution
The status area of the Port Setting menu for DDR VDCP
devices shows information about the selected port, a video
port, and a list of response times.
DDR VDCP detailed settings screen
1
Press [DDR Type].
A popup window opens.
2
Select Player or Recorder.
Player: Functions as player.
Recorder: Functions as recorder.
3
Using any of the following methods, select the video
port or a response time to set.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
Setting values
0 to 255