Sony MKS-2010 User Manual page 74

To switch the video instantly ([CUT] button)
To execute a transition at a specified transition rate ([AUTO TRANS] button)
To execute a transition with the fader lever
About fader lever non-sync
74
Executing Transitions
Fader lever
AUTO TRANS button
Fader lever
CUT button
AUTO TRANS button
1.5 M/E panel
Note
When modifications (Position, Aspect, and so on) have been applied to effects,
the video may not switch smoothly, and afterimages may remain visible even
after transitions have finished executing.
Press the [CUT] button in the transition execution section.
The video switches between the A bus and the B bus with each press of the
button.
Press the [AUTO TRANS] button in the transition execution section.
The progress of the transition is shown by the transition indicator LEDs, which
light one after the other as the transition proceeds.
Move the transition lever from one side to the other at any speed. Once you do
this, you can control the transition manually.
The transition indicator LEDs light one after the other as you move the lever to
execute the transition.
If an auto transition finishes with the fader lever in an intermediate position, the
lever position does not match the current transition position. This state is called
"non-sync."
Two of the transition indicator LEDs light to indicate a non-sync state, either at
the top of the lever range, at the bottom of the range, or at both sides.
CUT button
CUT button
AUTO TRANS button
1 M/E panel
Fader lever