Wiring; Precautions; Power Supply - HOKUYO AUTOMATIC UST-05LN User Manual

6. Wiring

This chapter describes precaution to take during wiring.

6.1 Precautions

During electric wiring make sure that all devices are disconnected from power supply. Switch off all the
power supply during wiring.

6.2 Power supply

Make sure that power supply is either DC 12V or DC 24V (operation voltage range 10V to 30V)
In case rated output voltage exceeds this range, UST could be damaged.
When a converter is used as power supply, make sure it fulfills the following requirements.
・ A rated output voltage within range of DC 10V to 30V (more than 1A)
・ The power supply must comply with the requirements of electromagnetic compatibility (EMC) regulations
of the respective country, states and district.


For safety, switch off all the power supply during wiring.
If there is an electric potential difference between the UST and ground of
other connected devices, there is a possibility of malfunction due to noise or
of damage. Prevent this by using potential equalization, isolation, etc.
Document No: C-41-02490-9
35