Troubleshooting Guide - Taylor 8752 Operating Instructions Manual

Section 8
PROBLEM
1. No product is being
dispensed.
2. Insufficient mix in the
freezing cylinder.
Models 8752 & 8756 with Horizon® Pump

Troubleshooting Guide

PROBABLE CAUSE
a. Low on mix. The "MIX
OUT" light is on.
b. The power switch is in the
OFF position.
c. The beater motor is out on
reset.
d. The beater assembly is
rotating counterclockwise.
e. Insufficient mix in the
freezing cylinder.
f. Restriction in the door
spout.
g. Machine is unplugged.
h. Circuit breaker is off or the
fuse is blown.
i. The mix probe was not
installed properly, or was
damaged.
a. Suction line is not fully
submerged in the mix.
b. The suction tube is
kinked.
c. The draw rate is set
incorrectly.
37
REMEDY
a. Add mix to the mix tank
and press the AUTO key.
b. Place the power switch in
the ON position and press
the AUTO key.
c. Reset the freezer.
d. Contact service technician
to correct rotation to
clockwise.
e. Refer to problem #2.
f. Remove the draw handle
and raise the draw valve
all the way up to remove
restriction. Never put
objects or fingers in door
spout.
g. Plug machine into the wall
receptacle.
h. Turn the breaker on or
replace the fuse.
i. Check the mix probe
installation.
a. Arrange the suction line
so the weighted end is
fully submerged.
b. Be certain the tube is not
obstructed.
c. Set the draw rate to
deliver 1/2 oz. per second.
Troubleshooting Guide
PAGE
REF.
15
-- -- --
15
-- -- --
-- -- --
-- -- --
-- -- --
-- -- --
29
29
-- -- --
17