Priming - Taylor 8752 Operating Instructions Manual

Priming

Step 1
Sanitize the mix tank, mix tank cover, mix probe, mix
storage cover and the funnel. Place the mix tank and
the cover in the mix cabinet.
Step 2
Insert the prongs of the mix probe inside the mix tank
and connect the mix probe in the socket receptacle.
Figure 52
Step 3
Place the free end of the suction line down in the mix
tank.
Figure 53
Models 8752 & 8756 with Horizon® Pump
Step 4
Install the funnel. Fill the mix tank with fresh mix.
Note: Use only fresh mix when priming the freezer.
Step 5
Remove the funnel and install the mix storage cover.
Close the mix cabinet door.
Step 6
Place an empty pail beneath the door spout. Open the
draw valve and pull the prime plug up.
29
Figure 54
Figure 55
Operating Procedures