Troubleshooting Guide; Section 8 Troubleshooting Guide - Taylor C712 Operating Instructions Manual

Section 8
PROBLEM
1. No product is being
dispensed.
2. The product is too soft.
Important: Operator Checklist

Troubleshooting Guide

PROBABLE CAUSE
a. Low on mix. The MIX
OUT light is on.
b. The power switch is in the
OFF position.
c. Machine not in AUTO
mode.
d. Beater motor is out on
reset. The BEATER
OVERLOAD message
displayed.
e. The pump motor is not
running in the AUTO
mode.
f. Freeze-up in mix inlet
hole.
g. The mix pump ball crank
is broken.
h. Feed tube or check ring
not properly installed.
i. Butterfat buildup in the
pump.
a. Draw rate is set too fast.
36
REMEDY
a. Add mix to the mix
hopper. Return to AUTO
mode.
b. Place the power switch to
ON and select AUTO.
c. Select AUTO and allow
machine to cycle off
before drawing product.
d. Turn the machine off.
Press the reset button.
Restart the machine in
AUTO.
e. Push the pump reset
button. Check pump motor
is operating when the
draw valve is raised.
f. Call an authorized service
technician.
g. Call an authorized service
technician.
h. Make sure feed tube and
rubber check ring are
properly installed.
i. Carefully remove the mix
pump, clean and reinstall.
a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
PAGE
REF.
30
29
30
- - -
15
- - -
- - -
27, 30
32
25
Model C712