Important: Operator Checklist; During Cleaning And Sanitizing; Troubleshooting Bacterial Count; Regular Maintenance Checks - Taylor 8752 Operating Instructions Manual

Section 7

During Cleaning and Sanitizing

Cleaning and sanitizing schedules are governed
by federal, state, or local regulatory agencies,
and must be followed accordingly. If the unit
has a "Standby mode", it must not be used in
lieu of proper cleaning and sanitizing
procedures and frequencies set forth by the
ruling health authority. The following check
points should be stressed during the cleaning
and sanitizing operations.
CLEANING AND SANITIZING MUST BE
PERFORMED DAILY.
ALWAYS FOLLOW LOCAL HEALTH CODES.

Troubleshooting Bacterial Count

j 1. Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
j 2. Use all brushes supplied for thorough cleaning.
The brushes are specially designed to reach all
mix passageways.
j 3. Use the long (38") white bristle brush to clean
the mix feed tube which extends from the mix
reservoir to the rear of the freezing cylinder.
j 4. Use the black bristle brush to thoroughly clean
the rear shell bearing located at the rear of the
freezing cylinder. Be sure there is a generous
amount of cleaning solution on the brush.
j 5. IF LOCAL HEALTH CODES PERMIT THE
USE OF RERUN, make sure the mix rerun is
stored in a sanitized, covered stainless steel
container and is used the following day. DO
NOT prime the machine with rerun. When using
rerun, skim off the foam and discard, then mix
the rerun with fresh mix in a ratio of 50/50 during
the day's operation.
Models 8752 & 8756 with Horizon® Pump

Important: Operator Checklist

j 6. On a designated day of the week, run the mix as
j 7. Properly prepare the cleaning and sanitizing
j 8. The temperature of the mix in the mix storage

Regular Maintenance Checks

j 1. Replace scraper blades that are bent, damaged
j 2. Before installing the beater, be certain that the
j 3. Check the rear shell bearing for signs of wear
j 4. Using a screwdriver and cloth towel, keep the
j 5. Dispose of o--rings and seals if they are worn,
j 6. Follow all lubricating procedures as outlined in
35
low as feasible and discard after closing. This
will break the rerun cycle and reduce the
possibility of high bacteria and coliform counts.
solutions. Read and follow the label directions
carefully. Too strong of a solution may damage
the parts and too weak of a solution will not do
an adequate job of cleaning or sanitizing.
Sanitize the freezing cylinder for 5 minutes.
cabinet and the walk--in cooler should be below
40_F. (4.4_C.).
or worn.
scraper blades are properly attached over the
pins and the beater assembly is straight.
(excessive mix leakage in the rear drip pan) and
be certain it is properly cleaned.
rear shell bearing and the female hex drive
socket clean and free of lubricant and mix
deposits.
torn, or fit too loosely, and replace with new
ones.
"Assembly".
Important: Operator Checklist