Beverage Connection - LINDR PYGMY 20 Instructions For Use Manual

ATTENTION!
Before you screw the silicone plastic fitting onto the thread
5/8, make sure that there is a silicone non-return valve on the
keg coupler (air in let).
6.
Screw the plastic fitting F 5/8x8.0 mm onto the coupler (air
in let)

Beverage connection:

7.
Connect the cooling system with a coupler by inserting 3/8
into the plastic fitting, which is placed on the back part of
thecooler.
8.
Insert the beverage tube 3/8 going from the cooling machine
into the plastic fitting F5/8 x 9,5 mm (outlet for the beverage
on the keg coupler)
9.
Connect the air supply onto the plastic fitting F 5/8 x 8 mm or
connect with built-in compressor.
For models with inbuilt air compressor the process of connecting an airtube is the same as
with the beverage tube, the only difference are the used plastic fittings and the tube 5/ 16.
The plastic fitting on the back of the cooler is labelled with an AIR sign. (see connection
A.,C.)
ˇ
21 FLOW TYPE CONTACT COOLER LINDR
silikone
valve
air inlet
beverage
inlet