Container Stop And Shelf Stop Positions; Using A Basic Hand Control; Using A Comfort Hand Control - LOGICDATA SMARTneo-2G Manual

S 4
The display shows S and a number (e.g. S 4)
Press the DOWN Key until the display shows S 0.
S O
The display shows S 0.
SAVE
Press the SAVE Key.
The SMARTneo-2G has now been reset to its factory settings. It is now in the same
state as it was during the first start-up.

8.4 CONTAINER STOP AND SHELF STOP POSITIONS

These features can limit the movement area of the Table Top (if e.g. a container is below the table or a shelf
is above it). Container Stop Positions become the new lowest end position, Shelf Stop Positions the highest.
Container Stop Positions can only be saved only in the lower half of the movement
INFO
area, Shelf Stop Positions in the upper half. You must set each position separately.

8.4.1 USING A BASIC HAND CONTROL

To Save a Container Stop or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the desired position
Press and hold the UP Key and DOWN Key for 10 seconds.
▸ The Container Stop / Shelf Stop Position is saved (Container Stop if you are in
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
Press and hold the UP Key and DOWN Key for 10 seconds.
▸ The Container Stop / Shelf Stop Position is deleted (Container Stop if you are

8.4.2 USING A COMFORT HAND CONTROL

To Save a Container Stop or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the desired position
2. Press and hold the SAVE Key for 10 seconds
SAVE
▸ The Control Box will click twice.
▸ The Container Stop / Shelf Stop Position is saved
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a
Shelf Stop Position) or bottom half (Container Stop Position) of the movement
area.
SMARTNEO - OPERATING MANUAL // PAGE 24
the bottom half of the movement area, Shelf Stop if you are in the top half).
in the bottom half of the movement area, Shelf Stop if you are in the top half).