Saving A Memory Position; Using A Basic Hand Control; Using A Comfort Hand Control - LOGICDATA SMARTneo-2G Manual

INFO
The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-de-
fined stopping point has been reached.
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached

7.2 SAVING A MEMORY POSITION

7.2.1 USING A BASIC HAND CONTROL

This function saves a set Table Top position. One "Stand" Memory Position can be saved in the top half of the
range of movement, one "Sit" Memory Position in the bottom half.
1. Move the table to the desired height
2. Press and hold the UP Key and DOWN Key simultaneously ("S" Key if available)
3. Press the UP Key to Save a Standing Position or the DOWN Key to Save a Sitting
Position.
▸ The Memory Position is saved
To delete a Memory Position with a Basic Hand Control, move to the Memory Position you wish to delete and
repeat steps 2 and 3.

7.2.2 USING A COMFORT HAND CONTROL

This function saves a set Table Top position. One Memory Position can be saved per Memory Position Key.
1. Move the table to the desired height (Chapter 5.1.1, Adjusting the Table Top height)
7 3
▸ The display shows the Table Top height (e.g. 73 cm)
SAVE
2. Press the SAVE Key.
2
3. Press the Memory Position Key (e.g. 2)
s 2
▸ The display shows S 2
SMARTNEO - OPERATING MANUAL // PAGE 20
(Chapter 5.1.1, Adjusting the Table Top height)