Canon FAX-L260i Service Manual page 161

5.2.5 New SSSWs/parameters added to this model
#1 SSSW (service soft switch setting)
SW01 (service soft switch 01: error management)
Bit Function
0 Service error code
1 Error dump list
2 Rx image data transfer
3 Copy function
4 (New) ##300 series service error code
5 Not used
6 Date & Time setting restriction
7 User setting restriction
[Bit 4]
Even when Bit0 is set to "NOT OUTPUT", you can select whether or not to output ##300 series
Service Error Codes, caused by hardware malfunction.
When "OUTPUT" is selected, ##300 series Service Error Codes are displayed and included in reports.
When "NOT OUTPUT" is selected, no Service Error Codes are displayed.
#3 NUMERIC PARAM. (numeric parameter settings)
No. Function
10 T0 Timer
11 T1 Timer (Rx)
13 Maximum time to receive one
line of image data
[No. 10]
The "wait time after transmission of a dialing signal ends until a significant signal is detected in trans-
mission" was formerly designated as T1 timer with parameter 10.
The T1 timer for the transmitter (wait time after a significant CED or V21 flag significant
signal is detected until the next significant signal is detected) is fixed at 35 seconds.
NOTE
[No. 11]
Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant signal is
received.)
If frequent errors occur during reception (2 instances) because of line connection conditions, raise the
value of this parameter.
[No. 13]
Set the maximum time to receive one line of image data when image data is received.
If the other party is a computer fax and the time to receive one line of image data is long, raise the value
of this parameter to increase the maximum reception time.
FAX-L260i Chapter 3: Maintenance & Service
1
Output
Output
Yes
No
Output
Setting restricted
Setting possible
Selecting range
0-9999
0-9999
500-3000
3-65
0
Not output
Not output
No
Yes
Not output
Setting possible
Setting restricted
Default setting
5500 (55 sec.)
3500 (35 sec.)
1300 (13 sec.)