Canon FAX-L260i Service Manual page 106

FAX-L260i Chapter 3: Maintenance & Service
• Scanning problems (Evaluation criteria: Test printing is good, but the copied image is
poor.)
• The document is not fed.
The document feed motor does not run.
The document slips against the rollers.
The document does not separate.
The scanner unit's sensors are defective
• The scanning image is abnormal.
Nothing is printed.
The image has vertical stripes.
The image has thick vertical stripes.
• Communication problems
• D-channel connection error
• Cannot perform G4 communication.
• Cannot receive.
4.2 Errors Shown on the Display
4.2.1 User error message
Look for the applicable error message and implement the appropriate countermeasures.
"BUSY/NO SIGNAL" (#005/#018)
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
"CHECK DOCUMENT" (#001)
Cause:
Solution:
"CHECK PAPER SIZE"
Cause:
Solution:
"CHECK PRINTER" (##322~##324, #335)
Check the displayed error code and see the measure to eliminate the error. ( See Page 3-17. )
The receiving fax did not answer within 55 seconds. (T0 time over)
Contact the other party and have them check their fax.You can try to send the docu-
ment manually.
The other party is not using a G4/G3 machine.
Contact the other party and have them send or receive the document using a G4/G3
machine.
The other party's fax is not working.
Contact the other party and have them check their fax.
The telephone number you dialed is busy.
Try sending the document at a later time.
Document jam. This is displayed when the document sensor detects paper, but the
document edge sensor cannot detect the leading edge of the document with 15 sec-
onds from the start of the feed operation.
Clear the document jam.
The size of the paper loaded in the paper tray is different from the paper size set by the
user data menu.
Set the correct paper size in the user data setting.
3-10
Page 3-51
Page 3-52
Page 3-52