ILX Lightwave LDC-3926339 User Manual page 64

LASER:ENABle:COND
Parameters
Notes
Examples
LASER:ENABle:COND?
Parameters
Notes
Examples
02_03
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The LASER:ENABle:COND command sets the Laser Condition Status Enable register. The bits in
this register determine which bits in the Laser Condition Status register are summarized in the LDC-
3926 Status Byte.
An <nrf value> whose sum represents the enabled bits:
1 - Current Limit
2 - Voltage Limit
4 - n/a
8 - Power Limit
16 - Interlock Disabled
32 - n/a
64 - n/a
128 - Open Circuit
This register can be read using the LASER:ENABle:COND? query.
See the Status Reporting section of the LDC-3926 manual for more information regarding condition
reporting.
LASER:ENAB:COND 9-action: the only conditions from the selected module that will be reported to
the LDC-3926 Status Byte are the Power Limit (8) and Current Limit (1) conditions.
The LASER:ENABle:COND? query returns the value of the Laser Condition Status Enable register.
None. The response is the sum of the following:
1 - Current Limit
2 - Voltage Limit
4 - n/a
8 - Power Limit
16 - Interlock Disabled
32 - n/a
64 - n/a
128 - Open Circuit
The enabled laser conditions can be set by using the LASER:ENABle:COND command.
The LASER condition status can be monitored by the LASER:COND? query.
LASER:ENAB:COND?-response: 258, means that only the following two conditions will be reported
(in summarized form) to the LDC-3926's Status Byte: Output Shorted (256) and Voltage Limit (2).
Note that the "Output Shorted" condition is the same as "Output Off".
C O M M A N D R E F E R E N C E
GPIB Command Reference
256 - Output Shorted
512 - Output In Tolerance
1024 - Output On
2048 - n/a
4096 - n/a
8192 - n/a
16384 - n/a
32768 - n/a
256 - Output Shorted
512 - Output In Tolerance
1024 - Output On
2048 - n/a
4096 - n/a
8192 - n/a
16384 - n/a
32768 - n/a
4
C H A P T E R
47
LDC-3926339