ILX Lightwave LDC-3926339 User Manual page 55

C O M M A N D R E F E R E N C E
4
C H A P T E R
GPIB Commands
Table 4.1 Command Summary
NAME
LASER:ENAB:COND
LASER:ENAB:COND?
LASER:ENAB:EVE
LASER:ENAB:EVE?
LASER:ENAB:OUTOFF
LASER:ENAB:OUTOFF?
LASER:EVE?
LASER:LDI
LASER:LDI?
LASER:INC
LASER:LDV?
LASER:LIM:I
LASER:LIM:I?
LASER:LIM:MDP
LASER:LIM:MDP?
LASER:LIM:V
LASER:LIM:V?
LASER:MDI
LASER:MDI?
LASER:MDP
LASER:MDP?
LASER:MODE?
LASER:MODE:IHBW
LASER:MODE:ILBW
LASER:MODE:MDI
LASER:MODE:MDP
LASER:MOD
LASER:MOD?
LASER:OUT
LASER:OUT?
LASER:SET:LDI?
LASER:SET:MDI?
LASER:SET:MDP?
38
LDC-3926339
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PARAMETERS FUNCTION
1 Sets the conditions that will affect the All Condition register.
NONE Returns the value of the Condition Enable register.
1 Sets the events that will affect the All Event register.
NONE Returns the value of the Event Enable register.
1 Sets the enable register with conditions that will turn off the
output.
NONE Returns the value of the Outoff Enable register.
NONE Returns the value of the Event register.
1 Sets the constant current source set point value.
NONE Returns the constant current source measured value.
2 Increases the current source set point value by one or
more steps with user-programmable delay between steps.
NONE Returns the measured laser voltage value.
1 Sets the laser current source limit.
NONE Returns the laser current source limit.
1 Sets the constant optical power (from monitor PD) limit
value.
NONE Returns the optical power (from monitor PD) limit value.
1 Sets the current source's adjustable compliance voltage.
NONE Returns the value of the adjustable compliance voltage
setting.
1 Sets the monitor current set point.
NONE Returns the monitor PD current measured value.
1 Sets the constant optical power set point
NONE Returns the actual monitor PD power value
NONE Returns the mode:
ILBW (constant current, low bandwidth),
IHBW (constant current, high bandwidth),
MDP (constant optical power) or
MDI (constant monitor current).
NONE Sets the mode to constant current, high bandwidth.
NONE Sets the mode to constant current low bandwidth mode.
NONE Sets the mode to constant monitor current mode
(regardless of CALPD value).
NONE Sets the mode to constant optical power mode.
1 Enables or disables the channel's modulation input.
NONE Returns the status of the channel's modulation input.
1 Turns the current source output on or off.
NONE Returns the current source output status.
NONE Returns the constant I (current) set point.
NONE Returns the constant optical power set point.
NONE Returns the constant P (optical power) set point.