Initial Inspection; Installing The Module Into The Mainframe; Installing The Module - ILX Lightwave LDC-3926339 User Manual

I N T R O D U C T I O N A N D S P E C I F I C A T I O N S
1
C H A P T E R
Product Overview

Initial Inspection

When you receive your LDC-3926339 module, check for shipping damage
immediately. Shipping damage is not covered under warranty. Contact ILX
Customer Service (see page xii for contact information) if the module appears to
have shipping damage.
Verify that the module has an ESD protective hood on the combo-D connector
and that it is enclosed in an ESD safe handling bag (when shipped separately
from the mainframe). Remember to follow proper ESD safe handling procedures
before handling the module.

Installing the Module into the Mainframe

These instructions are for installing the LDC-3926339 module into the LDC-3926
mainframe.
Static discharge can damage your new Laser Diode Controller Module. Be certain you
use proper grounding procedures before unpacking and installing your module(s) into
the LDC-3926 mainframe.
Inspect the module for any visible shipping damage that may have occurred
before inserting the module into the mainframe. Pay special attention to the
copper shielding material on the right edge of the rear panel of the module.
Be sure that the LDC-3926 mainframe power is off before inserting or removing any
module. Inserting or removing a module while the mainframe power is on is known as
hot-swapping.
Hot swapping may cause hardware, calibration data, and memory damage or loss. Module
damage from hot-swapping is NOT covered under warranty.

Installing the Module

1
2
3
4
2
LDC-3926339
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Unwrap the module from the anti-static bag.
Make sure the LDC-3926 mainframe is turned off.
Align the top and bottom edges of the module with the plastic guides in the desired slot on
the mainframe. Make sure the copper shielding is facing the power entry side of the rear
panel.
Carefully slide the module, 40-pin connector first, into the LDC-3926 mainframe until the
connector is seated. Make sure to seat the module. The rear panel of the module is flush
with the mainframe when properly inserted.