Gpib Commands; Table 4.1 Command Summary - ILX Lightwave LDC-3926339 User Manual

This chapter is a guide to all of the commands for the LDC-3926339 6-Amp
module. It contains an overview of the remote commands used by the module,
shown in Table 4.1, as well as detailed command descriptions, listed in
alphabetical order.

GPIB Commands

Table 4.1 Command Summary

NAME
*CAL?
*CLS
*ESE
*ESE?
*ESR?
*IDN?
LASER:BIAS
LASER:BIAS?
LASER:CALPD
LASER:CALPD?
LASER:CAL:ABORT
LASER:CAL:DEFAULT
LASER:CAL:LDI
LASER:CAL:LDV
LASER:CAL:MDI
LASER:CAL:MEAS
LASER:CAL:STAT?
LASER:COND?
LASER:DEC
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
C
OMMAND
PARAMETERS FUNCTION
none Used for the A/D calibration procedure.
1 Resets the Standard Event Register, Status Byte and Error
Queue to zero.
1 Used to load the Standard Event Status Enable register.
none Sets the summary bit (bit 5) in the Status Byte.
none Returns the value of the Standard Event Register.
none Returns the DEVICE IDENTIFICATION string.
1 Enables or disables the 5 V reverse photodiode bias.
NONE Returns the status of the photodiode bias control.
1 Used to set the CAL PD (monitor responsivity) constant.
NONE Returns the CAL PD (monitor responsivity) constant.
NONE Aborts a calibration.
NONE Restores calibration values to their defaults.
NONE Starts the constant current source calibration mode.
NONE Starts the voltage measurement calibration mode.
NONE Starts the monitor photodiode current calibration mode.
1 Enters a calibration value.
NONE Returns a value which represents the calibration status.
NONE Returns the value of the condition register.
2 Decreases the set point value by one or more steps with
user-programmable delay between steps.
4
C H A P T E R
R
EFERENCE
37
LDC-3926339