Sullair E900H User Manual page 42

E900H USER MANUAL
7. Apply a light film of clean fluid to each ele-
ment gasket surface.
8. Center the new elements on filter housing
heads and tighten until the filter gaskets
make contact with the filter housing. After
gaskets make contact, tighten 1/2 to 2/3 of a
turn.
9. Run compressor and check for leaks.
42
Figure 6-3: Main Fluid Filter Assembly and Thermostat
1. Cap Screw
2. Washer
3. Upper Housing
4. O-Ring
02250203-986 R01
A F M
IR ILTER AINTENANCE
Refer to Figure 6-4. Air filter maintenance should be
performed when indicated on the restriction indicator.
The air filters are equipped with a primary element
and secondary element.
The secondary element must be replaced after every
third primary element change. DO NOT reconnect
the secondary element once it is removed.
5. Thermostat Element
6. O-Ring
7. Lower Housing
8. Filter Elements
SECTION 6