Laminating - Otto Bock Harmony P3 Technical Information

3.8.3 Laminating

Objective
The ThermoLyn PETG layer is laminated with carbon.
Required tools and materials
• 616T483=3 ThermoLyn PETG
Harmony System
Roughen the plastic with sandpaper and clean with iso­
propyl alcohol.
NOTE: Do not use acetone or thinners. These sub­
stances damage the plastic.
Carry out the first lamination process.
Clamp the plaster model with the laminate into the
transfer device.
Establish the connection between the prosthetic socket
and the prosthesis components (e.g. with a sealing res­
in/talcum mixture or hard foam)
Carry out the second lamination process.
If a sleeve protector is to be produced: Produce the
sleeve protector before cutting the prosthetic socket
(see Page 22).
Cut the course of the socket brim.
Procedure
Ottobock | 21