• Indicators:
a)
Power (Green LED)
b)
Protection (Yellow LED)
c)
Alarm (Red LED)
OPERATION
AC Input Protection Device Requirements/Recommendations
Refer to the system documentation supplied with the system the rectifier is installed in.
Local Indicators
Location and Identification: Refer to Figure 10.
Description: There are three (3) indicators located on the rectifier's front panel. The functions of these
indicators are as shown in Table 14.
NOTE!
DC voltage must be present at the rectifier output terminals (from battery or an operating
rectifier) or AC voltage at the input terminals.
Rectifier High Voltage Shutdown and Lockout Restart
Procedure
1.
Turn the power to the rectifier off or remove the rectifier, wait 30 seconds or more (until the LEDs on
the rectifier extinguish), then turn the power to the rectifier on or re-insert the rectifier.
Figure 10:
Local Indicator Locations
Vertiv
| NetSure Rectifier Module User Manual (UM1R482000e / 11BU1360YY) | Rev. J
24