Preparing The Machine To Print; Installing / Cleaning The Laser Protective Glass - SINTERIT Lisa Pro Shortened User Manual

2. Preparing the machine to print

A. INSTALLING / CLEANING THE LASER PROTECTIVE GLASS
CAUTION!
Beware of sharp edges. Put on the safety gloves in order to protect yourself from injuring
the hand against the edge of the heating module.
1. Turn of the safety key
2. While holding the heater module (Image 4 and 7), take out the split pin
part of the lid .
3. Lower the heating module to get access to the place dedicated for the LASER PROTECTIVE GLASS
4. Unscrew two knurled nuts
5. Remove the module from the locking holders
Image 7. Heater module - split pin system.
6. Rub the surface of glass carefully with a cotton
cloth soaked with 2% salicylic acid (ethanol solution)
or any other ethanol-based solution. Do not use
isopropyl alcohol! Pay attention to any fibers left
on the surface. Clean both sides (Image 10).
switch and turn off the power switch
from the LASER PROTECTIVE GLASS module (Image 9).
located in the middle of the lid.
Image 9. Correct unmounting of the LASER PROTECTIVE GLASS.
.
positioned on the top of the inner
Image 8. Heater module - opening.
Image 10. Correct unmounting of the LASER
PROTECTIVE GLASS.
Sinterit Lisa PRO USER MANUAL (short version) | 5
(Image 8).