Initial Setup By Basic Setup - Panasonic KX-HNB700 User Manual

Troubleshooting
→Perform one of the following.
– If you want to connect your mobile device to the wireless router which the camera is
connected with:
Reconnect your mobile device to the router whose WPS button was pressed, restart the
[HomeHawk] app, and then follow the on-screen instructions.
– If you want to connect your camera to the wireless router which the mobile device is
connected with:
Press and hold the RESET button until you hear a beep (about 10 seconds) using an object with
a thin tip ( "Resetting camera settings", Page 76) and restart the [HomeHawk] app. Then press
the WPS button on the router which your mobile device is connected with.
R The "Isolation" function on the wireless router is enabled.
Sometimes when the "Isolation" function is enabled, the camera will not be able to communicate with
your mobile device via your wireless router.
→Disable the "Isolation" function on your wireless router. For details, refer to your wireless router's
manual.
The camera's LED indicator is lit in yellow.
R The camera is not in WPS mode because the SETUP button was not pressed for long enough.
→Follow the on-screen instructions, and press and hold the SETUP button on the camera until it
beeps (about 5 seconds).
The camera's LED indicator is blinking quickly in green.
The camera is searching for your wireless router. Check the following causes/solutions first and wait until
the LED indicator is lit in blue. Then restart the [HomeHawk] app.
R The camera and wireless router are too far away.
→Move the camera and wireless router closer together.
R A network clash has occurred because you have 2 wireless routers at home that are using the same
channel or channels of a close frequency.
→Unplug all the wireless routers and plug them in again.
If the situation still does not improve, refer to your wireless router's manual for information on how to
change the router channel of your wireless network.

Initial setup by Basic Setup

Initial setup can't be completed
The camera's LED indicator is blinking in red.
If you have trouble during the initial setup check the following causes/solutions first and then turn off the
camera and restart it.
R The wireless network password may be incorrect.
→Enter the correct password for the wireless network.
R The DHCP function of your wireless router may be disabled.
→Enable the wireless router's DHCP settings. For details, refer to your wireless router's manual.
The camera's LED indicator is lit in blue.
R Your mobile device is connected to another network.
→Connect your mobile device to the same wireless network that was used to set up the camera and
try to add the mobile device again.
R A network clash has occurred because you have 2 wireless routers at home that are using the same
channel or channels of a close frequency.
→Unplug all the wireless routers and plug them in again.
142