System Expansion; System Expansion (Overview) - Panasonic KX-HNB700 User Manual

Getting started with the HomeHawk!
*1 You can configure the camera so that its LED indicator does not light in most states. See "Status",
Page 70.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from "Camera signal strength", Page 70.
*3 Lights for 3 seconds after registration is successfully completed or failed.
Shelf camera LED indicator
Off
Green
Red
Yellow
Blue
White
*1 You can configure the camera so that its LED indicator does not light in most states. See "Status",
Page 70.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from "Camera signal strength", Page 70.
*3 Lights for 3 seconds after registration is successfully completed or failed.

System expansion

System expansion (overview)

You can expand the system by registering additional devices. See "What kinds of devices are
available?", Page 6 for information on the types and number of devices that can be registered.
28
R No power
R LED indicator is turned off
Registration successfully completed
Registration mode, updating
Camera is searching for your wireless router
*3
Registration failed , signal level is weak
*1
R Streaming data or detecting motion
R Accessing microSD card (when privacy mode is off)
R Camera is out of range of your wireless router
R Wireless LAN connection failed
Not registered to your wireless router (usually for initial setup), or signal
*2
level is good
Initial setup is being performed using WPS on your router
Registration to your wireless router successfully completed or camera is
*1
on
*1
Privacy mode is on
Accessing microSD card (when privacy mode is on)
*1
*3
or signal level is strong
*2
*1
*2
*2